Understanding Mitsubishi Triton L200 dashboard warning lights is crucial for preventing mechanical failures and ensuring driver safety. Immediate attention to red alerts can avoid breakdowns, while amber/green indicators help maintain optimal performance.

Quick Navigation
Red Warning Lights (Stop Immediately)
Brake System Alert

Low brake fluid or hydraulic failure. Park safely and avoid driving until serviced.
Low Oil Pressure

Critically low oil level or pump malfunction. Stop the engine and check oil level immediately.
Battery Charge Warning

Faulty alternator, battery, or electrical connection. Stop driving to prevent stalling.
Engine Overheating

Coolant temperature critically high. Turn off the engine and check coolant level.
Airbag System Fault

Airbag sensors or connectors disrupted. Seek immediate service to restore safety features.
Power Steering Failure

Steering system malfunction. Restart the vehicle; if persistent, avoid driving.
Door/Trunk Ajar

Door or trunk not fully closed. Secure properly to prevent accidents.
Seat Belt Reminder

Driver/passenger unbuckled. Fasten immediately for safety.
Security Alert

Anti-theft system error. Check key or sensor interference.
Coolant Level Warning

Low coolant. Refill promptly to avoid engine damage.
Glow plugs Failure

Cold-start issues in diesel engines. Service glow plugs to prevent ignition problems.
Tire Pressure (Rapid Loss)

Fast air leakage detected. Check for punctures and inflate.
Transmission Fault

Gearbox malfunction. Stop driving to prevent further damage.
Diesel Particulate Filter (Blocked)

Severely clogged filter. Avoid short trips; drive at highway speeds to regenerate.
Dynamic Control Malfunction

ABS or stability control failure. Drive cautiously and service immediately.
Yellow/Amber Warning Lights (Action Required Soon)
Check Engine Light

Engine or emissions system issue. Schedule diagnostics to avoid long-term damage.
Low Washer Fluid

Windshield fluid reservoir low. Refill for clear visibility.
Service Due

Routine maintenance overdue. Schedule inspection.
4WD System Fault

Transfer case or sensor issue. Check drive mode or service if light persists.
Bulb Failure

Exterior light malfunction. Replace faulty bulb promptly.
Keyless Access Fault

Smart key not detected. Replace battery or reposition key.
Lane Departure Warning

Sensor blocked or system error. Clean windshield camera.
Low Fuel

Fuel level critically low. Refuel promptly.
Overdrive Off

Transmission not shifting optimally. Check settings or service.
Eco Mode Inactive

Fuel-saving mode disabled. Reset or diagnose underlying issue.
Green Warning Lights (Information Only)
Cruise Control Active

Speed set and maintained. Deactivate when not needed.
High Beam Indicator

Headlights on high beam. Switch to low beam in traffic.
Front Fog Lights

Fog lights engaged. Turn off in clear conditions.
Rear Fog Lights

Enhanced rear visibility in fog. Disable when visibility improves.
Turn Signals

Blinkers in use. Cancel after lane changes or turns.
Parking Sensors

Obstacle detection system operational. No action required.
Ready Indicator (Hybrid)

Vehicle powered on. Normal operation.
Auto Hold Active

Brakes automatically hold at stops. Release via accelerator.
Gear Indicator

Current transmission gear shown. Automatic mode requires no input.
Start/Stop System

Engine temporarily off at stops. Functioning normally.
Ambient Lighting

Interior lights active. Adjust via settings.
Seat Heater/Cooler

Climate control active for seats. Adjust as needed.
Navigation Guidance

Route directions displayed. Follow prompts or mute system.
When looking at Mitsubishi, make sure to check out our guides on models like the Mitsubishi Canter, Mitsubishi Fuso, Mitsubishi ASX, and Mitsubishi Mirage. Understanding dashboard warning lights is essential. Our expert reviews break down what each light means, highlighting common alerts for these models and what they could signal about underlying issues, so you’re never left guessing behind the wheel.


